The story behind the official Raspberry Pi case

Here’s a great post over at the Foundation written by Gordon Hollingworth. It describes in details the trials and tribulations (or possible tribble-ations, for those Trekkies amongst you) of producing an injection moulded case for the Pi. This new official case is available from the Swag Store, element14, or RS Electronics. (or MCM Electronics, Newark and Allied if you’re outside the UK) Read more here.

1 comment for “The story behind the official Raspberry Pi case

  1. Bonzadog
    17 June 2015 at 9:33 am

    A somewhat off the topic subject, but I would like to see:

    1) A Pi case that could take an extra board fpr sensors , hats etc…..pehaps even space for a HDD.

    2) A decent Camera Case – I have seen Camera cases in amazon, but they all receive poor ratings.

    Just an Idea

    BD

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.